Perhaps a silly suggestion;
if you do a 'darcs apply' and paste the patch in; be sure to type
control-d (twice?) to mark the end of the patch.
On Tue, Feb 01, 2005 at 10:19:59PM +0900, Yamagata Yoriyuki wrote:
> Hi,
>
> darcs apply does not seem to terminate on my repository. Judging from
> its size (2000 lines of code, developed for about one month), I do not
> think it is just a slowness. Memory usage does not increase during the
> execution. The patch comes from my coworker's repository. Until
> today, I did development by myself, so had not used "apply" command.
> record, get commands work without problem. Also, pushing to a empty
> repository works, too. "darcs verify" reports the repository is
> consistent.
>
> Unfortunately, I cannot show you a repo., since it is proprietary
> software. Only difference from "usual cases" is that we use Japanese
> comments in patches in the repos. (on the other hand, an applied
> patch does not contain Japanese comments) Is darcs 8-bit clean? darcs
> version is 1.0.1
>
> I would appreciate any suggestion. Tomorrow, I will try to reproduce
> the problem on a smaller example.
--
Thomas Zander
pgpAI3aAVwjzb.pgp
Description: PGP signature
_______________________________________________
darcs-users mailing list
darcs-users@xxxxxxxxx
http://www.abridgegame.org/mailman/listinfo/darcs-users
|
