Hi,
darcs apply does not seem to terminate on my repository. Judging from
its size (2000 lines of code, developed for about one month), I do not
think it is just a slowness. Memory usage does not increase during the
execution. The patch comes from my coworker's repository. Until
today, I did development by myself, so had not used "apply" command.
record, get commands work without problem. Also, pushing to a empty
repository works, too. "darcs verify" reports the repository is
consistent.
Unfortunately, I cannot show you a repo., since it is proprietary
software. Only difference from "usual cases" is that we use Japanese
comments in patches in the repos. (on the other hand, an applied
patch does not contain Japanese comments) Is darcs 8-bit clean? darcs
version is 1.0.1
I would appreciate any suggestion. Tomorrow, I will try to reproduce
the problem on a smaller example.
--
Yamagata Yoriyuki
|
