> brctl setfd br0 1
> brctl sethello br0 1
These should be zero, if you're following my howto I updated it about a week
ago to reflect this. Not that this will fix your problem, it's only a minor
point.
> tunctl -u root
> /sbin/ifconfig tap0 0.0.0.0 promisc up
> brctl addif br0 tap0
>
> route add default gw $GW_IP
>
> What should i do after this point?
Now you need to launch a UML instance and configure its eth0 device using
ifconfig from within the session, and set the gateway.
This page should help: http://edeca.net/articles/bridging/start-uml.html
Specifically you're looking for the "eth0=tuntap,uml-conn0" added to your
commandline. What goes in place of "uml-conn0" is probably "tap0" but seems
you don't specify a name when in your "tunctl" command when you create the
device I cannot say for sure.
David
-------------------------------------------------------
This SF.net email is sponsored by: SF.net Giveback Program.
Does SourceForge.net help you be more productive? Does it
help you create better code? SHARE THE LOVE, and help us help
YOU! Click Here: http://sourceforge.net/donate/
|
