Re: Package selection in T2

> I am new to T2 and my first try to build a small i386 installation
> (based on T2 trunk) ends up in a question where I currently
> haven't found any answer in the docs:
> 
> If I build an i386 installation with a minimalistic package
> selection and then tell T2 to use runit instead of sysvinit I get an
> error because there is a shared file used. This maybe a problem
> because sysvinit and runit seems to be used. How can I disable selected
> packages and how can I enable them? I haven't found any hints about
> where to setup special selected packages...

To be able to add or remove any package you should select "Show expert
and experimental options" in the configuration menu. That will bring an
additional menu. In there you should select "Custom package selection"
and after it select "Edit package selection rules". To add a package to
your configuration you should place "X packagename" in the Package
selection rule. To remove a package that as been selected by default in
your target you should place "O packagename".

Miguel Queirós

----------------------------------------------------------- 
If you wish to unsubscribe from this mailing, send mail to
lists@xxxxxxxxxxxxxx with a subject of: unsubscribe t2