Re: Build-Target failed in linux-header (stage 0). Fixed by modifying base/linux24/linux-conf.in file

Hi,

Thanks for the tip. And you are correct that the "fix" I mentioned above was
only half way through. After the fix linux-header package indee compiled but
then it failed in 2.6.24 version of Linux26 package.

As a temporary fix I added following lines in linux-conf.in file:

if [ "$pkg" = "linux-header"]; then
  lx_cpu='echo ....sed mentioned above as a fix without the i386->x86
replacing'
else
  lx_cpu='echo ..... the original sed line here with i386->x86 replacing'
fi

However, this is just a temporary fix for myself because naturally this
breaks again when/if linux-header package is updated to 2.6.24 version.

Additional question. I tried to find env variable holding the version number
of the package but could not find one so I did the "fix" based on package
name. $pkg variable gives the package name but how can I find out the
package version shown in some status lines and package tar balls? Just in
case I sometimes need it in the future.

-- 
View this message in context: 
http://www.nabble.com/Build-Target-failed-in-linux-header-%28stage-0%29.-Fixed-by-modifying-base-linux24-linux-conf.in-file-tp15142869p15177207.html
Sent from the T2 mailing list archive at Nabble.com.