Re: [TMF4.1.1] lowlevel command to obtain endpoint ip address on NAT enabled TME

Gary,

If you configure the local_ip_interface during an EP install, would that 
information get sent in the initial login packet?

Jason 



Gary Hamilton wrote:

> So you are asking for the real address of the endpoint that is on the other
> side of a NAT firewall?
>
> This information would not be available to the Endpoint Manager. In a
> configuration like this, you would be using the name of the endpoint to
> communicate with it, and the name is converted by the appropriate naming
> service to an IP address, which will be converted to the real address when
> it passes through the firewall.
>
> An IP address may be stored in the Endpoint Manager database, but this
> address is very likely to be the NAT'd address, not the real one. Is this
> the IP address you are asking for?
>
>
> Gary R. Hamilton
> Team Leader
> Senior Software Engineer
> IBM Software Group - Tivoli Software (UK)
> Global Response Team - Europe/Middle East/Africa
> +44(0)1753-780-988
> mobile: +44(0)780-820-3714
> e-mail:hamilgar@xxxxxxxxxx
> ____________________________________________
> AskTivoli -  http://www-3.ibm.com/software/sysmgmt/products/support/
> Web PMR submission - http://www-3.ibm.com/software/support/probsub.html
>
>
>                                                                           
>             joel_n_mokoetle@b                                             
>             ankone.com                                                    
>             Sent by:                                                   To 
>             owner-tme10@lists         <tme10@xxxxxxxxxxxxxxxx>            
>             .us.ibm.com                                                cc 
>                                                                           
>                                                                   Subject 
>             24/02/2005 17:10          [tme10] [TMF4.1.1] lowlevel command 
>                                       to obtain endpoint ip address on    
>                                       NAT enabled TME                     
>             Please respond to                                             
>                   tme10                                                   
>                                                                           
>                                                                           
>                                                                           
>                                                                           
>
>
>
>
>
> Can someone please tell me the low level (i.e. objcall,idcall,etc.) command
> to obtain the IP ADDRESS of an endpoint on a Tivoli Management Environment
> that has NAT enabled? I need the IP as registered in on the TMR.
>
> Thanking you in advance,
> Napo
>
> ***************************************************************
> JPMorganChase - Systems & Service Management Tools Engineer
> Tel: 614-213-8599
> Pager: 888-636-2381
> "If you look in your dictionary, you'll find that the meaning of the word
> 'single' is not single!" UNKNOWN
> *************************************************************
>
> This transmission may contain information that is privileged, confidential
> and/or exempt from disclosure under applicable law. If you are not the
> intended recipient, you are hereby notified that any disclosure, copying,
> distribution, or use of the information contained herein (including any
> reliance thereon) is STRICTLY PROHIBITED. If you received this transmission
> in error, please immediately contact the sender and destroy the material in
> its entirety, whether in electronic or hard copy format. Thank you.
>
>
>