Re: [Fwd: [TMF4.1.1] lowlevel command to obtain endpoint ip address on NAT enabled TME]

Hi Jason,

If it's hidden, then I guess it may
exist. So my question then becomes, if the hidden IP ADDRESS of the endpoint
exists on the TMR somewhere, how can I retrieve it using Tivoli commands?

I need this because as a prereq, I am
checking if an instance of "an endpoint to be" already exists
in the TME before I allow the installation to continue. When I reject the
installation of the TMA code, I want to feedback the IP of the registered
endpoint to the installer. As such the TMA code may not even be running
on the target machine, though it's instance may still from previous installs
be existing in the TME (let's just assume a very bad change management
situation)!.
Perhaps if there's Tivoli support folks
on the list, they could also share their thought.

Kindly,
Napo
***************************************************************
JPMorganChase - Systems & Service Management Tools Engineer
Tel: 614-213-8599
Pager: 888-636-2381
"If you look in your dictionary, you'll find that the meaning of the
word 'single' is not single!"
************************************************************* 

This transmission may contain information that is privileged, confidential and/or exempt from disclosure under applicable law. If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution, or use of the information contained herein (including any reliance thereon) is STRICTLY PROHIBITED. If you received this transmission in error, please immediately contact the sender and destroy the material in its entirety, whether in electronic or hard copy format. Thank you.