Re: [Fwd: [TMF4.1.1] lowlevel command to obtain endpoint ip address on NAT enabled TME]

The whole purpose of NAT is keep that IP address hidden. The 
local_ip_interface parameter from the last.cfg might have the data, but 
that has to be populated at EP install time.

Jason Shamroski
Gulf Breeze Software
www.gulfsoft.com
Office = 919-386-0534

Home of the OpenESM Project
www.sourceforge.net/projects/gulfsoft



> Can someone please tell me the low level (i.e. objcall,idcall,etc.) 
> command to obtain the IP ADDRESS of an endpoint on a Tivoli Management 
> Environment that has NAT enabled? I need the IP as registered in on 
> the TMR.
>
> Thanking you in advance,
> Napo
>
> ***************************************************************
> JPMorganChase - Systems & Service Management Tools Engineer
> Tel: 614-213-8599
> Pager: 888-636-2381
> "If you look in your dictionary, you'll find that the meaning of the 
> word 'single' is not single!" UNKNOWN
> *************************************************************
>
> This transmission may contain information that is privileged, 
> confidential and/or exempt from disclosure under applicable law. If 
> you are not the intended recipient, you are hereby notified that any 
> disclosure, copying, distribution, or use of the information contained 
> herein (including any reliance thereon) is STRICTLY PROHIBITED. If you 
> received this transmission in error, please immediately contact the 
> sender and destroy the material in its entirety, whether in electronic 
> or hard copy format. Thank you.