[TMF4.1.1] lowlevel command to obtain endpoint ip address on NAT enabled TME

Can someone please tell me the low level
(i.e. objcall,idcall,etc.) command to obtain the IP ADDRESS of an endpoint
on a Tivoli Management Environment that has NAT enabled? I need the IP
as registered in on the TMR.

Thanking you in advance,
Napo

***************************************************************
JPMorganChase - Systems & Service Management Tools Engineer
Tel: 614-213-8599
Pager: 888-636-2381
"If you look in your dictionary, you'll find that the meaning of the
word 'single' is not single!" UNKNOWN
************************************************************* 

This transmission may contain information that is privileged, confidential and/or exempt from disclosure under applicable law. If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution, or use of the information contained herein (including any reliance thereon) is STRICTLY PROHIBITED. If you received this transmission in error, please immediately contact the sender and destroy the material in its entirety, whether in electronic or hard copy format. Thank you.