Hi
Brad,
The
message 'endpoint not connected' means that the framework believes the endpoint
to be unavailable. You verified that with 'wep [ep] status' ...
"connection reset by peer" means there is a problem connecting to the
endpoint. Restarting the endpoint may resolve this problem. You
haven't said if this is a Wintel or Unix endpoint, so I can't recommend the
precise troubleshooting steps you can use, but you could search the list
archives for "connection reset by peer" and you will find many discussions about
endpoint problems along with some good troubleshooting tips.
hth,
John
Guadagnino
Gap
Inc.
We are using Tivoli FW 411. I ran the command
wdmcmd -e <endpoint) -stop. This seemed to work fine. When running the
command wmdcmd -e <endpoint> -restart I received the following error
message.
The endpoint <epname> belongs to gateway
<tmr>-gateway is not connected (status is 3).
AMW0273E - The ITM Engine could not be started
on the endpoint +#TMF_Endpoint::Endpoint#.
When
running this command: wep exe52test_ep status - I get this error
message
Data was not received because the connection was
reset by the peer.
ipc_recv failed:
connection reset by peer <ip address>
