From: Arnaud Launay <asl@xxxxxxxxxx>
Le Tue, Jun 04, 2002 at 08:53:19AM +1000, Rusty Russell a écrit:
> > Patch enclosed corrects the following warning in 2.5.20:
> > aic7xxx_linux.c:401:27: warning: multi-line string literals are deprecated
> Wrong fix: remove the commas at the ends of lines...
Hm, found only one other driver using multilines
(drivers/media/video/c-qcam.c),
patch enclosed uses the same kind of params.
I hope I do not bother you, else just tell me.
Regards,
Arnaud.
--
Flexion, extension !
--- trivial-2.5.28/drivers/scsi/aic7xxx/aic7xxx_linux.c.orig Fri Jul 26
16:36:40 2002
+++ trivial-2.5.28/drivers/scsi/aic7xxx/aic7xxx_linux.c Fri Jul 26 16:36:40 2002
@@ -398,26 +398,26 @@
MODULE_LICENSE("Dual BSD/GPL");
#endif
MODULE_PARM(aic7xxx, "s");
-MODULE_PARM_DESC(aic7xxx, "period delimited, options string.
- verbose Enable verbose/diagnostic logging
- no_probe Disable EISA/VLB controller probing
- no_reset Supress initial bus resets
- extended Enable extended geometry on all controllers
- periodic_otag Send an ordered tagged transaction periodically
- to prevent tag starvation. This may be
- required by some older disk drives/RAID arrays.
- reverse_scan Sort PCI devices highest Bus/Slot to lowest
- tag_info:<tag_str> Set per-target tag depth
- seltime:<int> Selection Timeout(0/256ms,1/128ms,2/64ms,3/32ms)
-
- Sample /etc/modules.conf line:
- Enable verbose logging
- Disable EISA/VLB probing
- Set tag depth on Controller 2/Target 2 to 10 tags
- Shorten the selection timeout to 128ms from its default of 256
-
- options aic7xxx='\"verbose.no_probe.tag_info:{{}.{}.{..10}}.seltime:1\"'
-");
+MODULE_PARM_DESC(aic7xxx, "period delimited, options string.\n\
+ verbose Enable verbose/diagnostic logging\n\
+ no_probe Disable EISA/VLB controller probing\n\
+ no_reset Supress initial bus resets\n\
+ extended Enable extended geometry on all controllers\n\
+ periodic_otag Send an ordered tagged transaction
periodically\n\
+ to prevent tag starvation. This may be\n\
+ required by some older disk drives/RAID arrays.
\n\
+ reverse_scan Sort PCI devices highest Bus/Slot to lowest\n\
+ tag_info:<tag_str> Set per-target tag depth\n\
+ seltime:<int> Selection
Timeout(0/256ms,1/128ms,2/64ms,3/32ms)\n\
+\n\
+ Sample /etc/modules.conf line:\n\
+ Enable verbose logging\n\
+ Disable EISA/VLB probing\n\
+ Set tag depth on Controller 2/Target 2 to 10 tags\n\
+ Shorten the selection timeout to 128ms from its default of
256\n\
+\n\
+ options
aic7xxx='\"verbose.no_probe.tag_info:{{}.{}.{..10}}.seltime:1\"'\n"
+);
#endif
static void ahc_linux_handle_scsi_status(struct ahc_softc *,
--
Don't blame me: the Monkey is driving
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
|
