Stephen C. Tweedie wrote:
This does not look at *all* like a normal xen networking config:
# ifconfig
eth0 Link encap:Ethernet HWaddr 00:15:60:0B:ED:88
Interrupt:17
this implies that eth0 is a physical device;
eth0:0 Link encap:Ethernet HWaddr 00:15:60:0B:ED:88
inet addr:192.168.254.4 Bcast:192.168.254.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Interrupt:17
with an alias;
You were right, it seems that the eth0:0 alias had confused the network
startup scripts and they didn't set up the bridging and virtual
interfaces correctly.
In my case "brctl show" has been showing a "Function not implemented"
error in the interfaces column.
I got rid of the unnecessary (not anymore) alias from ifcfg-eth0:0 and
assigned it's IP address to ifcfg-eth0.
Restarting the network afterwards using the /etc/init.d/network script
didn't solve the problem, but rebooting the system did - all virtual
inferfaces and bridging started working properly.
Here's my current state:
[root@domzero2 ~]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:15:60:0B:ED:88
inet addr:192.168.254.4 Bcast:192.168.254.255 Mask:255.255.255.0
inet6 addr: fe80::215:60ff:fe0b:ed88/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3953 errors:0 dropped:0 overruns:0 frame:0
TX packets:3482 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:470410 (459.3 KiB) TX bytes:446958 (436.4 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:209 errors:0 dropped:0 overruns:0 frame:0
TX packets:209 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:32078 (31.3 KiB) TX bytes:32078 (31.3 KiB)
peth0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
UP BROADCAST RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:3989 errors:0 dropped:0 overruns:0 frame:0
TX packets:3485 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:488345 (476.8 KiB) TX bytes:463068 (452.2 KiB)
Interrupt:17
vif0.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3489 errors:0 dropped:0 overruns:0 frame:0
TX packets:3961 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:448316 (437.8 KiB) TX bytes:471006 (459.9 KiB)
xenbr0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:701 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:38658 (37.7 KiB) TX bytes:468 (468.0 b)
[root@domzero2 ~]# brctl show
bridge name bridge id STP enabled interfaces
xenbr0 8000.feffffffffff no peth0
vif0.0
[root@domzero2 ~]# netstat -nr
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt
Iface
192.168.254.0 0.0.0.0 255.255.255.0 U 0 0 0
eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
eth0
0.0.0.0 192.168.254.1 0.0.0.0 UG 0 0 0
eth0
[root@domzero2 ~]# dmesg | egrep '(eth|vif|xenbr)'
eth0: Tigon3 [partno(349321-001) rev 2100 PHY(5704)]
(PCIX:133MHz:64-bit) 10/100/1000BaseT Ethernet 00:15:60:0b:ed:88
eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] Split[0] WireSpeed[1]
TSOcap[0]
eth0: dma_rwctrl[769f4000]
eth1: Tigon3 [partno(349321-001) rev 2100 PHY(5704)]
(PCIX:133MHz:64-bit) 10/100/1000BaseT Ethernet 00:15:60:0b:ed:87
eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] Split[0] WireSpeed[1]
TSOcap[1]
eth1: dma_rwctrl[769f4000]
tg3: eth0: Link is up at 100 Mbps, full duplex.
tg3: eth0: Flow control is off for TX and off for RX.
eth0: no IPv6 routers present
device vif0.0 entered promiscuous mode
xenbr0: port 1(vif0.0) entering learning state
xenbr0: topology change detected, propagating
xenbr0: port 1(vif0.0) entering forwarding state
ADDRCONF(NETDEV_UP): peth0: link is not ready
tg3: peth0: Link is up at 100 Mbps, full duplex.
tg3: peth0: Flow control is off for TX and off for RX.
ADDRCONF(NETDEV_CHANGE): peth0: link becomes ready
device peth0 entered promiscuous mode
xenbr0: port 2(peth0) entering learning state
xenbr0: topology change detected, propagating
xenbr0: port 2(peth0) entering forwarding state
xenbr0: no IPv6 routers present
vif0.0: no IPv6 routers present
peth0: no IPv6 routers present
eth0: no IPv6 routers present
With xen, normally you have no physical eth0: eth0 is a virtual loopback
net device, the other end of which is bound to vif0.0; the original
physical eth0 is renamed to peth0; and vif0.0 and peth0 are bridged
together on xenbr0. So once I start a domU guest in such an
environment, bridging shows:
# brctl show
bridge name bridge id STP enabled interfaces
xenbr0 8000.feffffffffff no peth0
vif0.0
vif1.0
Your environment has no virtual eth0, no renamed physical peth0 and no
loopback vif0.0; it doesn't look like any of the dom0 bits that xen
tries to set up have been initialised. What sort of network config did
you have set up before starting xend? What does "brctl show" show?
Thanks for the hint, it has directed me on the right tracks!
BTW. Would it be possible to make the Xen network stuff support
migrating to Xen from a setup with aliases on physical interfaces, like
in my case?
I predict that this scenario will be quite typical of migrations to Xen:
imagine one has a server with multiple aliases on a physical interface
(because there are several services that depend on specifiv IP
addresses - as it was in my case).
Such a setup is of course a typical candidate for migrating to a
virtualized server setup with Xen - I think there will be more people
with setups like mine, wanting to switch to Xen as flawlessly as possible.
Not very nice that interface aliases currently aren't handled gracefully
- it would be good to make it work for next RHEL... What's your opinion?
--
Best Regards,
Aleksander Adamowski
GG#: 274614
ICQ UIN: 19780575
http://olo.ab.altkom.pl
--
Fedora-xen mailing list
Fedora-xen@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/fedora-xen
| 
