Hi!
I'm using xenguest-install.py to install a guest domain on x86_64.
The anaconda installer start up fine, but when I configure the network
for the guest domain (be it DHCP or static IP), after trying to contact
installation FTP server, I discover that the guest domain has no network
connectivity at all - it cannot resolve the FTP server's hostname, or
connect to it directly by its IP address; I cannot ping from other hosts
or from dom0 to the guest domain.
The physical network controller is a Broadcom Corporation NetXtreme
BCM5704 Gigabit Ethernet using the tg3 driver.
The virtual network devices are created by Xen on domain 0:
# ifconfig
eth0 Link encap:Ethernet HWaddr 00:15:60:0B:ED:88
inet addr:192.168.254.208 Bcast:192.168.254.255
Mask:255.255.255.0
inet6 addr: fe80::215:60ff:fe0b:ed88/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:475078 errors:0 dropped:0 overruns:0 frame:0
TX packets:601247 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:99094177 (94.5 MiB) TX bytes:322269097 (307.3 MiB)
Interrupt:17
eth0:0 Link encap:Ethernet HWaddr 00:15:60:0B:ED:88
inet addr:192.168.254.4 Bcast:192.168.254.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Interrupt:17
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:80137 errors:0 dropped:0 overruns:0 frame:0
TX packets:80137 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:288852189 (275.4 MiB) TX bytes:288852189 (275.4 MiB)
vif1.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:99 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:6 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4158 (4.0 KiB) TX bytes:0 (0.0 b)
xenbr0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:99 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2772 (2.7 KiB) TX bytes:468 (468.0 b)
I suspect that this may have something to do with x86_64 architecture
and the tg3 driver. Any ideas?
--
Best Regards,
Aleksander Adamowski
GG#: 274614
ICQ UIN: 19780575
http://olo.ab.altkom.pl
--
Fedora-xen mailing list
Fedora-xen@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/fedora-xen
| 
