Hello All !
I've just installed linux image from http://handhelds.org/~mreimer.
Everything seems to work well except one issue. After some suspend/resume
cycles iPAQ refuses to suspend again. This is last lines from dmesg:
Stopping tasks: ==============================================|
mq11xx: mismatch power on/off request count for subdevice 301
suspending dma channel 0
mmc0: host does not support reading read-only switch. assuming write-enable.
Restarting tasks... done
Stopping tasks: ==============================================|
mq11xx: mismatch power on/off request count for subdevice 301
suspending dma channel 0
mmc0: host does not support reading read-only switch. assuming write-enable.
Restarting tasks... done
usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet Subset
usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet Subset
usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet Subset
usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet Subset
usb0: no IPv6 routers present
Stopping tasks: =================================================call to
w1_ds2760_status failed (0xc3aca058)
=call to w1_ds2760_status failed (0xc3aca058)
=call to w1_ds2760_status failed (0xc3aca058)
=
stopping tasks failed (1 tasks remaining)
Restarting tasks...<6> Strange, w1_bus_master1 not stopped
done
Stopping tasks: ==================================================
stopping tasks failed (1 tasks remaining)
Restarting tasks...<6> Strange, w1_bus_master1 not stopped
done
Stopping tasks: ==================================================
stopping tasks failed (1 tasks remaining)
Restarting tasks...<6> Strange, w1_bus_master1 not stopped
done
Stopping tasks: ==================================================
stopping tasks failed (1 tasks remaining)
Restarting tasks...<6> Strange, w1_bus_master1 not stopped
done
Stopping tasks: =============================================
stopping tasks failed (1 tasks remaining)
Restarting tasks...<6> Strange, w1_bus_master1 not stopped
done
--
Best regards,
Vladimir
|