Hello
I am trying to boot the image from
http://familiar.handhelds.org/snapshots/v0.8.3/RC2/unsorted/gpe-image-v0.8.3-h2200.rootfs.tar.bz2
I have installed LAB as per the instructions at
http://www.handhelds.org/moin/moin.cgi/HpIpaqH2200LAB
When i installed LAB i got the CRC fail on the device but i also got
WRITE fail. Is this normal? I have restarted the device and i can see
the graphical LAB.
MMC formated as ext2, single partition and mounted under /mnt/mmc
Then i bunziped the rootfs and extracted with 'tar xvf
gpe-rootfs-bla-bla.tar -C /mnt/mmc'
I created a labrun file under /mnt/mmc/boot/ and added the following
contents:
copy fs:/mnt/boot/zImage fs:/zImage
umount /mnt
armboot fs:/zImage "root=/dev/mmcblk0p1"
saved, synced and unmounted the mmc card. Put it into the device and
rebooted. LAB appears to run (graphical invent freely logo etc), then
the screen becomes black and stays there forever.
I am doing something wrong. Could someone please give me some advice?
Thank you
Andreas
|
