ports.arm.general (thread)

Re: a question about porting kernel 2.6.7 to mx1ads, Pavel Pisa
kernel 2.6.7 mount problem in Motorola mx1ads, 严志军
sharp zaurus SL-6000, Relihan, Dan
RE: Suggestion needed on Arm Linux support for my PhilipsLPC2119/LPC2129 board, Charles Manning
AT91RM9200 SSC & SPI, Jarkko Loima
- Re: AT91RM9200 SSC & SPI, Yann Desplanches
Using the IXP425 High Speed Serial Interface Access Lib, Vanitha Ramaswami
- Re: Using the IXP425 High Speed Serial Interface Access Lib, Deepak Saxena
- RE: Using the IXP425 High Speed Serial Interface Access Lib, Vanitha Ramaswami
  - Re: Using the IXP425 High Speed Serial Interface Access Lib, Deepak Saxena
sshd w/o look for sshd_config, Annamalai Prakash
- Re: sshd w/o look for sshd_config, Mike Frysinger
Suggestion needed on Arm Linux support for my Philips LPC2119/LPC2129 board, Puneet
- Re: Suggestion needed on Arm Linux support for my Philips LPC2119/LPC2129 board, Marc Singer
  - Re: Suggestion needed on Arm Linux support for my Philips LPC2119/LPC2129 board, Mike Frysinger
  - Re: Suggestion needed on Arm Linux support for my Philips LPC2119/LPC2129 board, Shannon Holland
GUI with linux or wince?, ahgu
- Re: GUI with linux or wince?, jassi brar
RE: Linux-arm Digest, Vol 12, Issue 31, Poonam AGGRWAL
IR port to wondows hyperterminal, Justin Pashley
- Re: IR port to wondows hyperterminal, himba
which new processor to use?, ahgu
- Re: which new processor to use?, Jeff Sutherland
RE: 2.4.19-rmk6-pxa1 vs. 2.4.19-rmk7-pxa2 difference, Howard Cai
ixdp425 patches, Michal Raviv
- Re: ixdp425 patches, Lennert Buytenhek
  - Re: ixdp425 patches, Michal Raviv
sshd crash on ixdp425 board. prob. in __do_irq, Annamalai Prakash
- Re: sshd crash on ixdp425 board. prob. in __do_irq, Mike Frysinger
USB Network, Paul Houser
- Re: USB Network, Michael Opdenacker
Mailing list etiquette (again), Edward Robbins
- Re: Mailing list etiquette (again), Marc Singer
Init RAM DISK, Poornachandran, RajeshX
- RE: Init RAM DISK, David Mentre
How to use printf() through USART to print float numbers, kun liu
Re: Linux on CSB350, taoyong
PCMCIA e7xx, Matthew Ranostay
use uMon to run zImage, taoyong
xscale minicache, Phil Blundell
- Re: xscale minicache, Russell King - ARM Linux
  - Re: xscale minicache, Phil Blundell
    - Re: xscale minicache, Russell King - ARM Linux
    - Re: xscale minicache, Phil Blundell
Problem with tc on ixp425, Munro Biswal
Compiling gdb, Glenn R Heard Jr
- RE: Compiling gdb, Charles Manning
Glibc or Busybox problem: glibc 2.2.5 to 2.3.1?, Bob Wirka
- Re: Glibc or Busybox problem: glibc 2.2.5 to 2.3.1?, Ricky
openh323, tornado zhang
- Re: openh323, Catalin Marinas
Re: driver for samsungs arm ethernet mac, Curt Brune
2.6 kernel image problem, Derya Sezen
genext2fs size restriction, Wan Ahmad Zainie Wan Mohamad
- Re: genext2fs size restriction, Wolfgang Denk
Serial Synchronous Controller on AT91RM9200, Chandra Sekhar, G
(no subject), derya.sezen
- (no subject), xuhaoz
  - Re: (no subject), Deepak Saxena
Source Debugger, Matthew Ranostay
- Re: Source Debugger, Michael Burian
  - Re: Source Debugger, karthik bala guru
    - Re: Source Debugger, karthik bala guru
X server, himba
- Re: X server, Chris Gorman
  - Re: X server, Henry Margies
    - Re: X server, MiB
    - Re: X server, Chris Gorman
gdb, Matthew Ranostay
- Re: gdb, Deepak Saxena
  - Re: gdb, karthik bala guru
PCMCIA Kernel Panic e740, Matthew Ranostay
bootloader for s3c2410, Philip Blundell
- Re: bootloader for s3c2410, Wolfgang Denk
  - Re: bootloader for s3c2410, Shannon Holland
    - Re: bootloader for s3c2410, Wolfgang Denk
- Re: bootloader for s3c2410, Igor Trevisan
help about the macro in u-boot, Sxiao
- Re: help about the macro in u-boot, Wolfgang Denk
Using gdb, Glenn Heard
- Re: Using gdb, Ralph Siemsen
  - Re: Using gdb, Ralph Siemsen
    - Re: Using gdb, Marc Singer
Samba source code for Xscale architecture( Arm based), madhusudhan.gowda
- Re: Samba source code for Xscale architecture( Arm based), Ian Campbell
- Re: Samba source code for Xscale architecture( Arm based), Gerd Reichle
mechanism and strategy problem about driver, 代子为
Help Needed....Porting Linux to ARM720 Board..., Garimella Srinivasu
- Re: Help Needed....Porting Linux to ARM720 Board..., himba
  - Re: Help Needed....Porting Linux to ARM720 Board..., Dominic
incorrect percent of MTD partition when using "df", w h
q:u-boot /8Mflash, caihongtan
- Re: q:u-boot /8Mflash, himba
problem generating libstdc++ .so file building toolchain, JX Hsieh
telnetd for arm, Poornachandran, RajeshX
- Re: telnetd for arm, Kenneth Crudup
- Re: telnetd for arm, Catalin Marinas
- RE: telnetd for arm, Rick Woodring
  - RE: telnetd for arm, Kenneth Crudup
  - Re: telnetd for arm, Xiaoming DONG
    - Re: telnetd for arm, Kenneth Crudup
    - Re: telnetd for arm, Mike Frysinger
    - Re: telnetd for arm, Erik Mouw
- RE: telnetd for arm, Rick Woodring
how can i make sdram into selfrefresh?, li zhihua
Re: mysterious difficulty spawning init with 2.6.7 and 2.6.8-rc1, Chris Gorman
multi-ice-gdb-server for Linux, Steven Chang\(張鴻楨\)
q:u-boot/flash, caihongtan
Xscale joystick driver examples, 高兰芳
- Re: Xscale joystick driver examples, himba
- Xscale joystick driver examples, 高兰芳
How to avoid the padding of structure done by arm-gcc., Vanitha Ramaswami
- RE: How to avoid the padding of structure done by arm-gcc., raghavendra.hanumanthaiah
  - Re: How to avoid the padding of structure done by arm-gcc., Ralph Siemsen
- RE: How to avoid the padding of structure done by arm-gcc., Vanitha Ramaswami
  - RE: How to avoid the padding of structure done by arm-gcc., sanjeev ramachandran
  - RE: How to avoid the padding of structure done by arm-gcc., Ian Campbell
- RE: How to avoid the padding of structure done by arm-gcc., Vanitha Ramaswami
StrognARM C examples?, shiva ellendort
- Re: StrognARM C examples?, Erik Mouw
  - Re: StrognARM C examples?, Pascal Gauthier
  - Re: StrognARM C examples?, Andy T
    - Re: StrognARM C examples?, Mike Frysinger
    - Re: StrognARM C examples?, Andy T
    - Re: StrognARM C examples?, karthik bala guru
    - Re: StrognARM C examples?, Erik Mouw
How much time does a "inw()" take in pxa255 based platform???, lin min
- Re: How much time does a "inw()" take in pxa255 based platform???, Marc Singer
- Re: How much time does a "inw()" take in pxa255 based platform???, Nicolas Pitre
Internal compile error: internal error--unrecognizable insn using g++ 2.95.4, JX Hsieh
- Re: Internal compile error: internal error--unrecognizable insn usingg++ 2.95.4, Paul Chitescu
xkeymap mangling, Chris Gorman
- Re: xkeymap mangling, Ralph Siemsen
GPIO Pins on EP9301, Bob Wirka
- RE: GPIO Pins on EP9301, Stephen Beaver
  - Re: GPIO Pins on EP9301, Bob Wirka
    - Re: GPIO Pins on EP9301, Ray Lehtiniemi
- Re: GPIO Pins on EP9301, dpetrini
  - Re: GPIO Pins on EP9301, Bob Wirka
CRC error in cramfsck, w h
GDB for arm-linux-gcc programs/apps !!, karthik bala guru
- Re: GDB for arm-linux-gcc programs/apps !!, Martin Zwickel
  - Re: GDB for arm-linux-gcc programs/apps !!, Martin Zwickel
    - Re: GDB for arm-linux-gcc programs/apps !!, Michael Moedt
  - Re: GDB for arm-linux-gcc programs/apps !!, karthik bala guru
  - Re: GDB for arm-linux-gcc programs/apps !!, karthik bala guru
prism54 802.11g driver, Simon Wong
Serial and USB bootsrap for custom Motorola M9328 MX1 board, ppisa4lists
Transfer of a Intel HEX format file through I2c on IXP, Munro Biswal
- Re: Transfer of a Intel HEX format file through I2c on IXP, Deepak Saxena
  - Re: Transfer of a Intel HEX format file through I2c on IXP, Munro Biswal
    - Re: Transfer of a Intel HEX format file through I2c on IXP, Eric BENARD / Free
    - Re: Transfer of a Intel HEX format file through I2c on IXP, Erik Mouw
Re: Linux software selection, Amy Yap Hai Sin
2.6.6 compile problem, Derya Sezen
- Re: 2.6.6 compile problem, himba
- Re: 2.6.6 compile problem, Mike Frysinger
Booting: Unhandled fault: vector exception, Greg Sulfid
MX1 ADS bootloader, Jacky Lam
- Re: MX1 ADS bootloader, Wolfgang Denk
little Howto to compile a crosscompiler, Martin Laabs
eCos suitable to implement JVM?, Amy Yap
MX1 GPIO mapping, Jacky Lam
- Re: MX1 GPIO mapping, Russell King - ARM Linux
  - Re: MX1 GPIO mapping, Jacky Lam
    - Re: MX1 GPIO mapping, Eric BENARD / Free
- Re: MX1 GPIO mapping, Robert Schwebel
AT91RM9200 USART driver update, James Graves
soft-float compilation prolem, Glenn R Heard Jr
- Re: soft-float compilation prolem, Nicolas Pitre
The second time: PXA255 sleep suspend/resume problem!, li zhihua
- Re: The second time: PXA255 sleep suspend/resume problem!, Ian Campbell
- Re: The second time: PXA255 sleep suspend/resume problem!, li zhihua
  - Re: The second time: PXA255 sleep suspend/resume problem!, Ian Campbell
- Re: The second time: PXA255 sleep suspend/resume problem!, li zhihua
  - Re: The second time: PXA255 sleep suspend/resume problem!, Ian Campbell
- Re: The second time: PXA255 sleep suspend/resume problem!, Ian Campbell
New to ARM and Linux, Bootloader and Debug questions, Chandra Sekhar, G
RE: Registering a IXP2400 GPIO interrupt, Luc Rambaud
- RE: Registering a IXP2400 GPIO interrupt, Luc Rambaud
  - Re: Registering a IXP2400 GPIO interrupt, Russell King - ARM Linux
Problem with RTC on Intel IQ80321 running arm-linux, Xiaoming DONG
ADC on AT91RM9200-dk, Kevin Loewen
FW: PXA255 sleep suspend/resume problem!, li zhihua
Mailing List FAQ, Russell King - ARM Linux
- Mailing List FAQ, Russell King - ARM Linux
- Mailing List FAQ, Russell King - ARM Linux
- Mailing List FAQ, Russell King - ARM Linux
Mailing List Etiquette, Russell King - ARM Linux
- Mailing List Etiquette, Russell King - ARM Linux
- Mailing List Etiquette, Russell King - ARM Linux
- Mailing List Etiquette, Russell King - ARM Linux
C++ for embedded arm Linux., Justin Pashley
- Re: C++ for embedded arm Linux., David Anders
Problem with stat and fseek on PXA27x, Luca Piccarreta
display image on fb, himba
- Re: display image on fb, Michael Burian
  - Re: display image on fb, himba
- Re: display image on fb, Thomas Fröhlich
  - Re: display image on fb, himba
cross compiler to build native compiler for IXP425 big endian, Ken
telnetd error with embedded linux, Poornachandran, RajeshX
- Re: telnetd error with embedded linux, Ralph Siemsen
- Re: telnetd error with embedded linux, Catalin Marinas
AT91RM9200: 100Mbps network problem, roman
- Re: AT91RM9200: 100Mbps network problem, James Graves
how could i get the zImage form uClinux-dist-20040448?, zhang yan