Hi all,
this is my problem. I'm working with IXDP425 mother board and I want to test
the NPE ethernet interface (IXP0 and IXP1) with SmartBit 200 device. I do a
loop between Smartbit and IXDP425 using both ethernet interfaces. I'm using
this version:
linux-2.4.19
patch-2.4.19-rmk6
patch-2.4.19-rmk6-ds1
patch-2.4.19-rmk6-ds1-ycc1
ixp425AccessLibrary
all this stuff was included in ixdp425-0.2.tar.gz packet. The ethernet
interfaces are configured with two different subnet (IXP0=10.0.1.254 and
IXP1=10.1.1.254) and I've set ip_forward=yes. When I generate a full duplex
traffic with Smartbit between IXP0 and IXP1 I have some ethernet collision
even at low rate. For this reason I can't mesure the minimum bandwidth
without faillure. Is there any issue about collision problem for NPE
ethernet when I use them at the same time ?
Regards,
Arty.
_________________________________________________________________
Nuovo MSN Messenger 6.1 con sfondi e giochi! http://messenger.msn.it/
Provalo subito!
-------------------------------------------------------------------
Subscription options: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
FAQ/Etiquette: http://www.arm.linux.org.uk/armlinux/mailinglists.php
| 