Re: Pencentra 200?

Mirco Piccin wrote:

> Hi all (again).
> 
>> Hi All.
>> I'm an owner of a Pencentra 200.
>> Its microprocessor is a 129MHz Toshiba(R) TX3922 MIPS RISC CPU.
>>
>> So i've prepared a CF with :
>> netbsd-GENERIC.gz (renamed an ungzipped)
>> [ A gzipped NetBSD kernel containing code
>>
>>  for everything supported in this
>>  release. This kernel runs on Vr41xx
>>  and TX3922 CPUs only.
>> from :
>> ftp://ftp.netbsd.org/pub/NetBSD/NetBSD-3.1/hpcmips/INSTALL.txt
>> ]
>> and
>> pbsdboot.exe
>>
>> I have no problem to start pbsdboot.exe (using Oencentra 130 framebuffer
>> profile), but i have this error:
>> "Error: mapping interrupt vector failed".
>>
>> I know that it's a known problem (
>>
http://article.gmane.org/gmane.os.netbsd.ports.hpcmips/2069/match=pencentra),
>> but is there a solution??
> 
> Anyone has tried the netbsd 4.0 on pencentra 200?
> Any tips?
> 
> Regards
> M
Hi Mirco

The GENERIC kernel from 4.0 does not boot, but we have now fixed the problem
in -current compiling with i.e. TX3922, I could send you a kernel
(again :), if you do not like to set up a cross-compilation environment. I
recall, that last time you had problems to boot the kernel I sent you, was
it about the size of the mainmemory??

risto