I've got an AlphaStation 250 with a CMD Tech PCI0649 IDE controller attached
on the pci bus, but it won't detect the connected IDE hard disk... i've tried
multiple disks, multiple cables, etc. what would cause the controller to think
that there isn't a drive attached?
thanks!
--david
important parts of the dmesg:
# dmesg|grep pciide
pciide0 at pci0 dev 13 function 0 "CMD Technology PCI0649" rev 0x01: DMA, unused
(couldn't map registers), channel 0 configured to native-PCI, channel 1 configu
red to native-PCI
pciide0: using isa irq 10 for native-PCI interrupt
pciide0: channel 0 disabled (no drives)
pciide0: channel 1 disabled (no drives)
# dmesg|head
[ using 534272 bytes of bsd ELF symbol table ]
consinit: not using prom console
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2004 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 3.6 (GENERIC) #288: Fri Sep 17 17:34:23 MDT 2004
deraadt@xxxxxxxxxxxxxxxxx:/usr/src/sys/arch/alpha/compile/GENERIC
AlphaStation 250 4/266, 268MHz
8192 byte page size, 1 processor.
#
|
