Well I removed the second cpu, disconnected the floppy drive, and did a
fresh install and I still cannot boot my DS20 with OpenBSD 3.3. I followed
the procedure outlined in
> http://marc.theaimsgroup.com/?l=openbsd-alpha&m=105680898328410&w=2
but cannot find a device to boot from
131 tsp0 at tsc* flags 0x0
UKC> exit
Continuing...
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21264-4 (pass 3)
cpu0: Architecture extensions: 303<PAT,MVI,FIX,BWX>
tsc0 at mainbus0: 21272 Core Logic Chipset, Cchip rev 0
tsc0: 8 Dchips, 2 memory buses of 32 bytes
tsc0: arrays present: 512MB, 0MB, 0MB, 0MB, Dchip 0 rev 1
tsp0 at tsc0
pci at tsp0 bus 0 not configured
tsp1 at tsc0 not configured
WARNING: can't figure what device matches ""
root device: /dev/sd0a
use one of: halt
root device: help
use one of: halt
root device: ?
use one of: halt
root device: sd0a
use one of: halt
So the result is I still cannot boot my DS20 from the hard disk after a 3.3
install.
Any more suggestions?
----- Original Message -----
From: "Miod Vallat" <miod@xxxxxxxxx>
To: "Todd Seeleman" <seeleman@xxxxxxxxxxxxx>
Cc: <alpha@xxxxxxxxxxx>
Sent: Tuesday, July 01, 2003 11:06 AM
Subject: Re: HELP
> > I've installed OpenBSD for Alpha v 3.3 on a COMPAQ DS20. Everything
> > went well but I am unable to boot the system. Can anybody help? I've
> > attached a file with show config, show dev, boot, trace, & ps output.
>
> I already answered your initial message a few days ago. If you missed
> it, check in the mailing list archives at
> http://marc.theaimsgroup.com/?l=openbsd-alpha&m=105680898328410&w=2
>
> Miod
|
