Broken counters?

   Hi,
 
After few tries, we found out that 12.2(15)T5 on 3640 works with our voice card 
and VPDN L2 tunnels. Access lists are now applied, both IN and OUT, but input 
counters on serial interface are not? Output counter are ok, at least they seam 
ok. Any way how to correct this?
 
Srdjan
 
===================
Serial0/0 is up, line protocol is up
  Hardware is QUICC Serial
  Description: SMIN
  Internet address is 225.221.232.18/30
  MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,
     reliability 255/255, txload 138/255, rxload 1/255
  Encapsulation PPP, LCP Open
  Open: IPCP, loopback not set
  Restart-Delay is 0 secs
  Last input 00:41:42, output 00:00:00, output hang never
  Last clearing of "show interface" counters 07:05:21
  Input queue: 3/1000/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/100 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 1109000 bits/sec, 189 packets/sec
     8939 packets input, 175805 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     16 input errors, 3 CRC, 12 frame, 0 overrun, 0 ignored, 1 abort
     2241348 packets output, 1760183897 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions

 
 

_______________________________________________
cisco-nsp mailing list  cisco-nsp@xxxxxxxxxxxxxxx
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/