Resolved: firmware upload failure ?

Well to answer my own questions.

If you poke around a bit you will find a directory called conf which
has an upgrade directory inside of it.  Mine was empty by I think that
happened once I put HD on it.  That directory is re-created on the
hard drive so once I re-uploaded the firmware it went to the HD
instead of the memory.

I ended up going from V2.3R25 to V2.3R29 to 3.18 beta.

The documentation is a little on the rough side but thats due to the
path I had to take to get things done.  At some point in time when I
have time I should actually document things that I find working on this.

Someone mentioned that 10MB hubs caused problems with the SLUG, has
anyone else seen that?  I dont know of anything else that would have
caused any of the problems I experienced.  Well maybe the wobble in
the earths rotation was doing it :)

Peace,
Liquiz





[ Moderator Note: All static information is slowly moving to the Wiki at 
http://www.nslu2-linux.org ]