Can't connect after ResetSysConf

My problem. After upgrading to firmware Unslung-3.18-beta-
firmware.zip. I messed up and the Ready/status led started to flash 
red/green and the slug was "dead". I enterd RedBoot by telnet and 
did a ResetSysConf as described at "www.nslu2-
linux.org/wiki/HowTo/ResetSysConf" and used orginal firmware 2.3R25

Ewerything went OK, no errors, but then i try to connect via telnet 
or by webbrowser it can't find the slug. IP after reset should be 
192.168.1.77 but nope. My old IP 192.168.0.4 doesent work either...

What I can see from the leds it works OK but I can't connect to it!
Is it possible to set another IP adress from RedBoot or is it 
perhaps a SAMBA problem?

Anyone that can help me?

Thanks!

(PC XP SP2)







[ Moderator Note: All static information is slowly moving to the Wiki at 
http://www.nslu2-linux.org ]