Re: SAMBA setup as a Domain Controller

I'm trying to work on it too.

I did get my smb.conf configured to the point where I was able to get
a windows 98 machine to authenticate through the domain, but not an XP
pro machine.

Unfortunately, as soon as the slug rebooted, the settings were
overwritten.  I need to figure out how to configure things so that the
settings will persist and so that when changes are made via the
administrative pages, they will work.

I installed samba 3 using ipkg, but can't figure out how to configure
it.  I'm about to create a new samba 3 config file and append my
settings to the end of it from the samba 2 file and see if I can get
it to work.

Bob

--- In nslu2-linux-hHKSG33TihhbjbujkaE4pw@xxxxxxxxxxxxxxxx, "Don Jones" 
<donaldjones@xxxx> wrote:
> 
> Not sure if this one has been discussed yet, but would it be possible 
> to configure the Slug to act as an NT domain controller or member 
> server of a domain?





[ Moderator Note: All static information is slowly moving to the Wiki at 
http://www.nslu2-linux.org ]