fence_manual...

This is a multipart message in MIME format.
Hi Everyone,

I have a two-node cluster. I have built and installed the cluster sources
from cluster_0406282100 snapshot. I can bring up both nodes successfully,
however, seems like I have a brain split cluster in that each node thinks it
is the only node. I ran the cman_tool on each node as follows:

        cman_tool join -c OVLCluster -2 -n nodename

Furthermore, in the log messages I often see messages that require one 
of the nodes to be rebooted. Some times I see the message in both nodes'
/var/log/messages files. In this case, I reboot the node that needs to be
rebooted and run the "fence_ack_maual -s rebooted-nodename" on the 
other system after the reboot. The problem is that then I see the same messages
again on the rebooted node's messages file. Seems like the cluster is in
some kind of a loop wanting to reboot that node over and over again after
the reboot. 

Can anyone tell me what is going on? Also, I am running the ccsd, cman_tool,
 fence_tool, clvmd, vgchange commands by hand. What version of the clustering
software has nice scripts such as "cluster start"?

Thanks,
Caroline

----------------------------------------------------------------------------------------------
See our award-winning line of tape and disk-based
backup & recovery solutions at http://www.overlandstorage.com
----------------------------------------------------------------------------------------------