Re: SD card error with RamDisk Rescue

Hi,


automatic_jack wrote:
> Hi,
>
> I have finally gotten an SD card (SanDisk Ultra II, 2 GB) and I have
> tried to install Familiar with RamDisk Rescue but the card does not
> work under Linux (it works perfectly with WinCE), this is part of dmesg
> that I have have with ssh:

So RamdiskRescue installs to the card and THEN you rebooted,
or you used ssh to access RamdiskRescue?

> ......................................................................

[]

> cmdlinepart partition parsing not available
> Using builtin partition definition

Not sure I like that.
What are the contents of startup.txt ?

[]

> Subset mmc0: host does not support reading read-only switch. assuming
> write-enable. mmcblk0: mmc0:1432 SD02G 1985024KiB 
>  mmcblk0:<3>mmcblk0: error 2 transferring data
> end_request: I/O error, dev mmcblk0, sector 0
> Buffer I/O error on device mmcblk0, logical block 0
> mmcblk0: error 2 transferring data
> end_request: I/O error, dev mmcblk0, sector 0
> Buffer I/O error on device mmcblk0, logical block 0
>  unable to read partition table
> RAMDISK: Compressed image found at block 0
> usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet
> Subset VFS: Mounted root (ext2 filesystem).
> Freeing init memory: 84K
> mmcblk0: error 2 transferring data
> end_request: I/O error, dev mmcblk0, sector 0
> Buffer I/O error on device mmcblk0, logical block 0

[]

> .....................................................
>
>
> Now, I do not have a card reader, so what can i do?

Start RamdiskRescue again, go to information and 'SD Card'.
Post the results here and we'll see if there's something of
interest about this card.


Marcus.