Re: Kernel 2.4.18-rmk4 for cerfcube fails to boot.

On Sun, 2002-04-07 at 23:16, Ben Greear wrote:
> I have been trying to get a later version of the kernel
> to boot on my CerfCube.  (I have installed 2.4.9 and the
> Familiar Linux distribution.)
> 
> I cross-compiled a 2.4.18 kernel patched with 2.4.18-rmk4 patch.
> 
> The build was clean, but the kernel hangs after de-compressing.
> I used the kernel.config recommended by Intrinsyc (modified slightly).
> (It's attached if that helps...)
> 
> After flashing the zImage file onto the cube, I see this:
> 
> IBoot> boot
> Uncompressing Linux................................................... done, 
> booting the kernel.
>

try these:


CONFIG_VT_CONSOLE
CONFIG_SERIAL_SA1100
CONFIG_SERIAL_SA1100_CONSOLE
CONFIG_SA1100_DEFAULT_BAUDRATE



_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
http://www.arm.linux.org.uk/armlinux/mailinglists.php
Please visit the above addresses for information on this list.