Re: FYI breakout-gs mislabelling

I was told the following regarding the silkscreen on breakout-gs:
"the silkscreen has a minor error here -- the labels for STUART Tx/Rx are
swapped with the I2C labels -- both are on the board, just in swapped 
position from the labelling."

I was also told the following regarding the VCC signals:
"the Vcc which comes off from each set of connectors is not actually 3.3V 
as intended, but equal instead to the supply voltage. In the next and
subsequent batches, the boards will provide 3.3V on those pins labelled 
Vcc".

 -- Doug


Naveen Sastry wrote:

> It looks like the printing on the breakout-gs is a bit wrong.  The 4 
> vias in the bank labelled ST (next to the AC97 vias) are labelled "ST" 
> as in STUART but the pins are marked
>     (GND SDA VCC SCL).
> However, I think those markings apply to the i2c bus. I think the ST 
> pins should be marked
>     (GND TXD VCC RXD).
> Presumably the i2c bus is mislabelled in a corresponding manner.
>
> -Naveen 




-------------------------------------------------------
This SF.Net email is sponsored by the 'Do More With Dual!' webinar happening
July 14 at 8am PDT/11am EDT. We invite you to explore the latest in dual
core and dual graphics technology at this free one hour event hosted by HP, 
AMD, and NVIDIA.  To register visit http://www.hp.com/go/dualwebinar