Re: [2.6.8 ->] Problems, hci_usb dosn't work.

On Wed, 2004-09-22 at 20:38, Marcel Holtmann wrote:
> Hi Ian,
> 
> > > this problem was reported two or three times, but I am unable to
> > > reproduce it with my USB 2.0 host controllers.
> > 
> > ohci_hcd 0000:00:02.1: nVidia Corporation nForce2 USB Controller (#2)
> > ohci_hcd 0000:00:02.1: irq 185, pci mem f8818000
> > ohci_hcd 0000:00:02.1: new USB bus registered, assigned bus number 3
> 
> your IRQ looks very weird. I have never seen an IO-APIC system assigning
> IRQ 185 to any device. Does any other USB device works in conjunction
> with this controller?

2 joysticks, one 6in1 card reader and one muvodrive, it all works.
And, it registers the device correctly it just can't read from it.

And yeah i know, it's part of the nvidia workaround:
cat /proc/interrupts
           CPU0
  0:   91522201          XT-PIC  timer
  1:      17141    IO-APIC-edge  i8042
  8:          4    IO-APIC-edge  rtc
  9:          0   IO-APIC-level  acpi
 14:     341508    IO-APIC-edge  ide0
 15:    1917703    IO-APIC-edge  ide1
177:          0   IO-APIC-level  ohci_hcd
185:          0   IO-APIC-level  ohci_hcd
193:     347701   IO-APIC-level  ehci_hcd
201:    4266340   IO-APIC-level  EMU10K1
209:    3869397   IO-APIC-level  eth0
217:   11455874   IO-APIC-level  nvidia
NMI:       8253
LOC:   91523920
ERR:          0
MIS:          0

hurrm ohci_hcd should have data... hurrrm, it might be LKML related
after all.. =P
(I might have left the experimental 'ohci' support in ehci on in this
kernel.)

> > What controller do you use? and what usb1.1 driver?
> 
> I use a NEC controller with an OHCI for USB 1.1 stuff.

Heh ok 

-- 
Ian Kumlien <pomac () vapor ! com> -- http://pomac.netswarm.net

signature.asc
Description: This is a digitally signed message part