Re: Nec MobilePro P300

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Monday 03 November 2003 2:53 am, David Lodeiro wrote:
I'm going to respond to this line first, as it puts the rest of my email in
context:

> Has anyone actually tried this on the NEC MobilePro P300 ?

Bootloader is NOT supported on the NEC MobilePro P300. Had you succeeded in
programming it, you would've easily caused your device to fail. Do *NOT* try
installing bootldr on any device other than a supported iPAQ.

*However*, assuming you are working on a port, I'll explain the rest to you:

> BootBlaster Error
> erase_flash unlock status - >0xaa00aa
> Bootblaster Low Level Error
> error: from C:\Working\Bootblaster\Flashutils.cpp:968

Looks like your flash needs Vpp to be applied. Do you need to enable a GPIO?
This error would indicate that the flash hasn't got the right voltage to
program.

> BootBlaster Error
> program_flash cleanup
> unlock status -> 0xaa00aa

Bootblaster tries to clean up after itself and runs into the same issue.

> >0xea00008e, flashcontent
Looks like your flash is safe for now. Don't try reprogramming it again.

> Thanks in advance
> David L
/joshua

- --
Joshua Wise | www.joshuawise.com
GPG Key     | 0xEA80E0B3
Quote       | <lilo> I akilled *@* by mistake
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (GNU/Linux)

iD8DBQE/psNdPn9tWOqA4LMRAvdlAKCPNcz0s3CLQua2HkN/WTmG4A8RmACeLBBJ
5Be1pvB7dHege82nAXSZMSE=
=QPjo
-----END PGP SIGNATURE-----