On Wed, 2006-03-15 at 22:46 +0100, Erick Michau wrote:
> hi all,
>
> I am using catalyst-2.0-rc40 on an x86 with a 2006.0 stage3 as a seed
> stage.
> I am doing a livecd booting directly on xorg-x11 so I have
> successfully achieved:
> # catalyst2 -f livecd-stage1_template.spec
> # catalyst2 -f livecd-stage2_template.spec
> Here is the content of fsscript.sh:
> echo "/etc/init.d/mkxf86config start" >> /etc/conf.d/local.start
> echo "/etc/init.d/x-setup start"
> >> /etc/conf.d/local.start
> echo "startx"
> >> /etc/conf.d/local.start
> However, xorg breaks at startup and I found that the "speedo" module
> was the cause so I deleted it from xorg.conf and "startx" works.
>
> I was wondering if it is possible to pass some parameters to the
> xorg.conf file for when
> "/etc/init.d/mkxf86config start" is called in a different way than
> customizing the "/usr/sbin/mkxf86config.sh" file by hand?
>
> In my case I do not want that "speedo" module to be loaded (X breaks).
> Right now I am trying to adapt the "/usr/sbin/mkxf86config.sh" script
> to rebuild xorg.conf _without_ the "speedo" module and it is
> painful..so I am looking for an other way.
I'd just edit the script with my fsscript... Sorry...
Also, your init script should probably just go through livecd/rcadd
instead of adding them to local.start...
--
Chris Gianelloni
Release Engineering - Strategic Lead
x86 Architecture Team
Games - Developer
Gentoo Linux
signature.asc
Description: This is a digitally signed message part
|
