Re: Bug#509178: installation-reports: sparc fails to boot 2.6.26: Memory Address not Aligned

Hi Folks,

I've solved this trouble doing a COLD REBOOT.

It is very simple:

Turn off your server, and disconnect the power supply cable. Wait about
twice minutes and then turn on the server. Before do poweroff, I recommend
change the default load to CDROM device in order to avoid boot from Harddisk
device.
>From the ok prompt:
ok setenv boot-device cdrom

and then, 
ok reset-all

When the server has loaded, in the ok prompt:
boot cdrom

When you do not need anymore boot from cdrom, reboot the server and in the
ok prompt:
ok boot disk0:a
ok reset-all


Good luck..
F R



Joost van Baal-138 wrote:
> 
> Hi,
> 
> This might be the same bug as #509202.
> 
> I'll try to setup cu or minicom to collect kernel messages on tuesday,
> while I am at the university again.
> 
> FWIW, the boot fails in the same way with
> http://cdimage.debian.org/cdimage/lenny_di_rc1/sparc/iso-cd/debian-testing-sparc-netinst.iso
> , built on 20081104-23:58 :
> 
>  Allocated 8 Megs of memory at 0x40000000 for kernel
>  Loaded kernel version 2.6.26
>  Loading initial ramdisk (4284688 bytes at ....
>  Memory Address not Aligned
> 
> I'll try to get it to boot with the latest etch kernel on tuesday.
> 
> Thanks, Bye,
> 
> Joost
> 
> -- 
> Joost van Baal                            http://abramowitz.uvt.nl/
>                                                  Tilburg University
> mailto:joostvb.uvt.nl                               The Netherlands
> 
>  
> 

-- 
View this message in context: 
http://www.nabble.com/Bug-509178%3A-installation-reports%3A-sparc-fails-to-boot-2.6.26%3A-Memory-Address-not-Aligned-tp21088794p24762165.html
Sent from the Debian Boot mailing list archive at Nabble.com.


-- 
To UNSUBSCRIBE, email to debian-boot-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx