Re: bochs newbie

Daniel,
  It works :-) :-) :-) :-) :-) :-)

I could load the "ne" module with: modprobe ne io=0x280

Thank you very much,
Juan

----- Original Message -----
From: "Daniel Gimpelevich" <daniel@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
To: "Juan Bañuls" <bwhite546@xxxxxxxxxxx>
Cc: <bochs-developers@xxxxxxxxxxxxxxxxxxxxx>
Sent: Tuesday, November 18, 2003 6:53 PM
Subject: Re: [Bochs-developers] bochs newbie


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

You have PCI either turned off or not compiled in, which doesn't
matter, because ne2k doesn't use it. The debian 3.0r0 image doesn't
look for ne2k; you have to use modprobe with its ioport address. BTW,
you may have to run Bochs as superuser/administrator for ne2k to work.

On Tuesday, November 18, 2003, at 08:40  AM, Juan Bañuls wrote:

> Hi all,
> I have tried to set up networking in the Debian 3.0r0 image
> contributed by Robert Millan and downloaded from this site using Bochs
> 2.0.2 and 2.1pre. While there is no problem doing the same with the
> dlxlinux image, which has (I think) a linux kernel v1.3, the kernel
> resident in the debian image seems to fail when trying to detect the
> PCI bus, where the ne2k should be located (isn't it??). Also I
> have recompiled bochs in cygwin with the same results. These are some
> kernel messages produced by the Debian 3.0r0 image with Bochs 2.1pre:
>
> Buffer cache hash table entries: 131072 (order 7, 512k)
> Page cache hash table entries: 32768 (order 5, 128k)
> VFS: Diskquotas version dquot_6.4.0 initialized
> CPU: Intel Pentium 60/66 stepping 03
> Checking 386/387 coupling... OK, FPU using exception 16 error
> reporting.
> Checking 'hlt' instruction... OK.
> Checking for popad bug... OK.
> Intel Pentium with F0 0F bug - workaround enabled.
> POSIX conformance testing by UNIFIX
> bios32_service(0x49435024): not present
> PCI: No PCI bus detected
> Linux NET4.0 for Linux 2.2
> Based upon Swansea University Computer Society NET3.039
> NET4: Linux TCP/IP 1.0 for NET4.0
> IP Protocols: ICMP, UDP, TCP, IGMP
> TCP: Hash tables configured (ehash 131072 bhash 65536)
> Starting kswapd v 1.5
> Detected PS/2 Mouse Port.
> Serial driver version 4.27 with no serial options enabled
> ttyS00 at 0x03f8 (irq = 4) is a 16550A
> pty: 256 Unix98 ptys configured
> Real Time Clock Driver v1.09
> RAM disk driver initialized: 16 RAM disks of 4096K size
> loop: registered device at major 7
> hda: Generic 1234, ATA DISK drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> hda: Generic 1234, 504MB w/256kB Cache, CHS=1024/16/63
> FDC 0 is an 8272A
> md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
> scsi: <fdomain> Detection failed (no card)
> NCR53c406a: no available ports found
> sym53c416.c: Version 1.0.0
> qlogicisp : PCI not present
> eata_pio: No BIOS32 extensions present. This driver release still
> depends on it.
> Skipping scan for PCI HBAs.
> Failed initialization of WD-7000 SCSI card!
> IBM MCA SCSI: Version 3.2
> IBM MCA SCSI: No Microchannel-bus present --> Aborting.
> This machine does not have any IBM MCA-bus
> or the MCA-Kernel-support is not enabled!
> megaraid: v1.11 (Aug 23, 2000)
> aec671x_detect:
> NO PCI SUPPORT.
> 3w-xxxx: tw_scsi_detect(): No pci interface present.
> scsi : 0 hosts.
> scsi : detected total.
> Partition check:
> hda: hda1 hda2
> apm: BIOS not found.
> VFS: Mounted root (ext2 filesystem) readonly.
> Freeing unused kernel memory: 156k freed
> INIT: version 2.84 booting
> Activating swap.
> Unable to find swap-space signature
> ...
>
> when trying to set up the ethernet:
> ifconfig eth0 10.111.160.160
> SIOCSIFADDR: No such device
> eth0: ERROR while getting flags: No such device
>
> I have read somewhere in the bochs website that the PCI support is
> incomplete, but It works successfully in dlxlinux (I can do ftp's...).
>
> Any hints?
>
>
> Thank you for your time and effort...
>
> Juan
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (Darwin)

iD8DBQE/ulyHO/Dos2Fb9DQRAtZRAKC34QGpbaXxFf2LuxSYm7bqnQ8d8wCfbrBY
N4/zPKx95w4wj41F1s7nJg0=
=OZrq
-----END PGP SIGNATURE-----



-------------------------------------------------------
This SF.net email is sponsored by: SF.net Giveback Program.
Does SourceForge.net help you be more productive?  Does it
help you create better code?  SHARE THE LOVE, and help us help
YOU!  Click Here: http://sourceforge.net/donate/
_______________________________________________
bochs-developers mailing list
bochs-developers@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/bochs-developers


-------------------------------------------------------
This SF.net email is sponsored by: SF.net Giveback Program.
Does SourceForge.net help you be more productive?  Does it
help you create better code?  SHARE THE LOVE, and help us help
YOU!  Click Here: http://sourceforge.net/donate/