|
Hi all,
I have tried to set up networking in
the Debian 3.0r0 image contributed by Robert Millan and downloaded from this
site using Bochs 2.0.2 and 2.1pre. While there is no problem doing the same with
the dlxlinux image, which has (I think) a linux kernel v1.3, the kernel
resident in the debian image seems to fail when trying to detect the PCI
bus, where the ne2k should be located (isn't it??). Also I
have recompiled bochs in cygwin with the same results. These are some
kernel messages produced by the Debian 3.0r0 image with Bochs
2.1pre:
Buffer cache hash table entries: 131072 (order 7,
512k)
Page cache hash table entries: 32768 (order 5, 128k)
VFS: Diskquotas
version dquot_6.4.0 initialized
CPU: Intel Pentium 60/66 stepping
03
Checking 386/387 coupling... OK, FPU using exception 16 error
reporting.
Checking 'hlt' instruction... OK.
Checking for popad bug...
OK.
Intel Pentium with F0 0F bug - workaround enabled.
POSIX conformance
testing by UNIFIX
bios32_service(0x49435024): not present
PCI: No
PCI bus detected
Linux NET4.0 for Linux 2.2
Based upon Swansea
University Computer Society NET3.039
NET4: Linux TCP/IP 1.0 for NET4.0
IP
Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 131072
bhash 65536)
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial
driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4)
is a 16550A
pty: 256 Unix98 ptys configured
Real Time Clock Driver
v1.09
RAM disk driver initialized: 16 RAM disks of 4096K size
loop:
registered device at major 7
hda: Generic 1234, ATA DISK drive
ide0 at
0x1f0-0x1f7,0x3f6 on irq 14
hda: Generic 1234, 504MB w/256kB Cache,
CHS=1024/16/63
FDC 0 is an 8272A
md driver 0.36.6 MAX_MD_DEV=4,
MAX_REAL=8
scsi: <fdomain> Detection failed (no card)
NCR53c406a: no
available ports found
sym53c416.c: Version 1.0.0
qlogicisp : PCI not
present
eata_pio: No BIOS32 extensions present. This driver release still
depends on it.
Skipping scan for PCI HBAs.
Failed initialization of WD-7000 SCSI
card!
IBM MCA SCSI: Version 3.2
IBM MCA SCSI: No Microchannel-bus present
-->
Aborting.
This machine does not have any IBM
MCA-bus
or the MCA-Kernel-support is not enabled!
megaraid: v1.11 (Aug 23,
2000)
aec671x_detect:
NO PCI SUPPORT.
3w-xxxx:
tw_scsi_detect(): No pci interface present.
scsi : 0 hosts.
scsi :
detected total.
Partition check:
hda: hda1 hda2
apm: BIOS not
found.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel
memory: 156k freed
INIT: version 2.84 booting
Activating swap.
Unable
to find swap-space signature
...
when trying to set up the ethernet:
ifconfig eth0 10.111.160.160
SIOCSIFADDR: No such device
eth0: ERROR while getting flags: No such
device
I have read somewhere in the bochs website that the
PCI support is incomplete, but It works successfully in dlxlinux (I can do
ftp's...).
Any hints?
Thank you for your time and effort...
Juan
| 