Hi!
It would be very good if you could specify more than one interface in config so
if one interface goes down pgcluster would automatically switch to the next
configured interface!
Regards,
Markus S.
>> -----Ursprüngliche Nachricht-----
>> Von: pgcluster-general-bounces@xxxxxxxxxxxxx [mailto:pgcluster-general-
>> bounces@xxxxxxxxxxxxx] Im Auftrag von a.mitani@xxxxxxxxxxxxxx
>> Gesendet: Montag, 11. Dezember 2006 11:34
>> An: pgcluster-general@xxxxxxxxxxxxx
>> Betreff: Re: [Pgcluster-general] A working config requested...
>>
>> Hi Akos,
>>
>> > - pgreplicate states "not same host" for both hosts. I have 2 network
>> > cards in the machine, and I'm trying to use pgcluster on eth1.
>> > I have set up a hostname in /etc/hosts for that ip, but no luck
>>
>> In order to connect replication server and Cluster DB with specified
>> interface, it is need specified interface in Cluster DB side.
>> However, current PGCluster doesn't have a such configuration.
>>
>> OK, I'll try to add this configuration into 1.7.0rc2.
>>
>> Regards,
>> ------------------
>> At.
>> _______________________________________________
>> Pgcluster-general mailing list
>> Pgcluster-general@xxxxxxxxxxxxx
>> http://pgfoundry.org/mailman/listinfo/pgcluster-general
__________________________________________________________________________________
Dieses Mail wurde vom Infotech SecureMail Service ueberprueft und fuer sicher
befunden.
Fuer weitere Informationen zu Infotech SecureMail Service waehlen Sie bitte:
www.infotech.at
This email has been scanned by Infotech SecureMail Service and it has been
classified as secure.
For more information on Infotech SecureMail direct your web browser to:
www.infotech.at
|
