osdir.com

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Message received are always at QoS 0


you should either chose ActiveMQ Artemis 2.6.0 or ActiveMQ 5.15.4 as
Tim Bain mentioned.

On Fri, May 25, 2018 at 8:36 AM, 孙煜 <sunyu@xxxxxxxxxxx> wrote:
> Thanks for your information.
> ------------------ Original ------------------
> From: "Tim Bain"<tbain@xxxxxxxxxxxxxxx>
> Date: Fri, May 25, 2018 08:28 PM
> To: "ActiveMQ Users"<users@xxxxxxxxxxxxxxxxxxx>;
> Subject: Re: Message received are always at QoS 0
>
>
> At this point Apollo is a dead project with no ongoing development effort,
> no plan to do any, and no support from this mailing list. Use at your own
> risk.
>
> Tim
>
> On Thu, May 24, 2018, 9:26 PM 孙煜 <sunyu@xxxxxxxxxxx> wrote:
>
>> Thanks for your reply, Tim.
>>
>>
>> The broker is Apollo 1.7.1, and the client is based on Eclipse Paho 1.0.2,
>> with protocol MQTT v3.1. When I connect the same client to ActiveMQ, it is
>> correct, a QoS 1 message received.
>>
>>
>> When searching for answer, I found the unfixed issue: ActiveMQ Apollo MQTT
>> QoS always downgraded to 0 (
>> https://issues.apache.org/jira/browse/APLO-353)...
>>
>>
>> Best regards,
>> Sun Yu
>>
>> ------------------ Original ------------------
>> From:  "Tim Bain"<tbain@xxxxxxxxxxxxxxx>;
>> Date:  Thu, May 24, 2018 09:06 PM
>> To:  "ActiveMQ Users"<users@xxxxxxxxxxxxxxxxxxx>;
>>
>> Subject:  Re: Message received are always at QoS 0
>>
>>
>> What version of ActiveMQ are you using?
>>
>> What transport protocol are you using?
>>
>> Can you share your code that publishes the message?
>>
>> Tim
>>
>> On Thu, May 24, 2018, 6:50 AM 孙煜 <sunyu@xxxxxxxxxxx> wrote:
>>
>> > ------------------ Original ------------------
>> > From:  "孙煜"<sunyu@xxxxxxxxxxx>;
>> > Date:  Thu, May 24, 2018 08:45 PM
>> > To:  "users"<users@xxxxxxxxxxxxxxxxxxx>;
>> >
>> > Subject:  Message received are always at QoS 0
>> >
>> >
>> > Hi,
>> >
>> >
>> > The message published with QoS 1, and the topic subscribed with QoS 1
>> too,
>> > but the message received are always at QoS 0. How can I make it to QoS 1
>> ?
>> > Thanks a lot !
>> >
>> >
>> > Best regards,
>> > Sun Yu



-- 
Clebert Suconic